Specifications

• mfg_part_number Digi Connect ME® 9210
• Processor Type 32-bit Digi NS9210 processor
• ARM Core ARM926EJ-S
• Processor Speed 75 MHz
• Cache 4k I/D Cache
• Memory Base Population 2/4 MB NOR flash
• Flexible Interface Modules (FIMs) 300 MHz DRPIC165X CPU
• On-chip 256-bit AES Accelerator •
• Power Management Modes On-the-fly clock scaling
• Pins/Form Factor RJ-45 connector style with 20-pin micro pin header (Samtec FTS-110-01-F-DV-TR)
• High-Speed TTL Serial Interface Full signal support
• GPIO 10 shared
• SPI Master data rate up to 16.7 Mbps
• I2C v1.0 bus interface
• Flexible Interface Support (FIM) UART, 1-Wire, CAN
• Watchdog Timer (16-bit) •
• JTAG Interface Available on development modules only (P/N DC-ME-Y401-JT, DC-ME-Y402-[LX]-JT)
• On-Board Power Supervisor •
• Wave-Solderable Design No clean flux process
• Dimensions (L x W x H) Network Interface - Wired
• Physical Layer 10/100Base-T
• Data Rate 10/100 Mbps (auto-sensing)
• Mode Full- or half-duplex (auto-sensing)
• Connector RJ-45 w/ magnetics
• PoE Power Pass-Through Environmental
• Operating Temperature -40° C to +80° C (-40° F to +176° F)
• Storage Temperature -50° C to +125° C (-58° F to +257° F)
• Relative Humidity 5% to 90% (non-condensing)
• Altitude Power Requirements (3.3VDC)
• Maximum 450 mA (1.485 W)
• Typical 346 mA (1.14 W)
• Idle 186 mA (613 mW)
• Sleep Regulatory Approvals
• FCC Part 15 Class B, EN 55022 Class B •
• EN 61000-3-2 and EN 61000-3-3 •
• ICES-003 Class B, VCCI Class II, AS 3548 •
• FCC Part 15 Sub C Section 15.247 •
• IC RSS-210 Issue 5 Section 6.2.2(o) •
• EN 300 328, EN 301 489-17 •
• UL 60950-1, EN 60950 (EU) •
• CSA C22.2, No. 60950 •
• URL